Daffodils and Roses – New challenges in my soap making

For a few months now I have been eyeing up the Soap creators competition The Soap Challenge Club and this month was soap tops – either creating fancy texture on the top of the loaf, which is something I enjoy doing anyway, or piping. Now I have done a little cake decorating in the past, but never piped flowers, but I enjoy a challenge and thought it would be a good way to push myself to try new things and learn new skills (remember that “Coming Soon” bit on my home page, I’m thinking that soap flowers should be a part of that idea now!)

I practiced a little with butter icing, and thought that it wasn’t too hard to make something vaguely resembling a rose….and then I tried with soap. Yeah, it was not as easy at all – and very importantly remembering to NOT to lick the spoon!!!

The image you see to the right here is actually my third practice session, I wouldn’t be ashamed to put that on a soap, however I knew I’d need to get a little better for the competition. This little rosebud below is just right, and shows the small square of baking paper that I piped onto. I’m sure that there were people who bought a tool for this challenge that I could not get hold of without going online, and so I looked up making your own. Armed with a plastic jar lid and a cotton bud (cotton wool removed) I melted the end of the cotton bud and stuck it to the underside of the lid, and it worked a treat.

The daffodils came about from thinking of creating a soap where the flowers flowed from spring through to summer, autumn and winter, but it got a little too tricky to figure out (and my snowdrops came out terrible!) so I stuck with just the daffodils, and well being Bee Soap I couldn’t resist adding a little soap dough bee too.

Though I really like the bright vibrancy of the yellow soap, it is not quite as spot on as my roses and so it will be entered into the Bonus round of the competition. The hanger swirl in my roses soap came out so well too. My husband is particularly pleased as he was the one who made my swirl tool – out of a section of brake pipe (clean and unused of course!) So here it is, and fingers crossed that it gets some votes.